Optimisation and controls brought to a new level


Solixi automatically optimizes parameters of the water boiler for each building depending on the installed equipment, the energy consumption, weather conditions and tariffs.

For low temperature floor heating the energy from lowest and coolest parts of the water boiler is utilized. Warm water is being pre-heated twice, which helps saving hot water from upper part of the boiler for other purposes.

In order to enable maximum savings, hot and cold are not being mixed up.

Solixi minimizes heatlosses and optimizes efficiencies

Solixi minimizes heat losses and optimises efficiencies. It pays off to store hot and cold, but not for too long, because the temperatures will even out as time goes on. This will happen although the uniform insulation walls of the large three part Solixi boiler are many times thicker than those of traditional boilers.

The losses of heat transfer are small

Because Solixi is near, on the roof and next to the wall, the losses of heat transfer are small and transfer is quick. That makes is possible even for tens of Solixi water pumps’ temperatures to be optimised real time with the accuracy of one degree. Temperature sensors are in the water pipes, in the boiler, on the roof and in the building.

The boiler can be either hot or cold storage

The whole boiler can be at times hot storage or cold storage or neither one of these when  the efficiency of heat pumps is improved with small temperature differences.

The temperatures are always controlled indoors, outside at the boiler they sometimes vary a lot.

Solixi is afterwise. Controls are improved and new acquisitions are made based on the statistics produced by the Solixi Care-service and analysis of the experts. If your neighbour’s Solixi works better, you will get its controls free of charge and unawares.

 

Versatile configurations


Pumps, heat exchangers and temperature sensors are connected to Controller. All pumps can be doubled (durability, power) several times. Low cost and adjustable flow pumps can be added or easily replaced. In the first-time installation there are typically 8 pumps and typically 12 temperature sensors. More features can be activated when needed. One pump, temperature sensor and heat exchanger model, one spare part, which maintenance changes in a moment; shut the lock, threads open, change the part, threads close and lock open.

Solixi care reports about the usage of the system

Solixi Care informs about malfunctions, alerts and calibrates itself to be still more accurate. Solixi Care shows, even on your phone, graphically where, how much and when energy is transferred and euros are saved.

Hundreds of software features

There are multiple pumps, heat exchangers, temperature sensors and software features in Solixi  compared to traditional solar energy systems, even hundreds. Automatic Solixi Care-steering, no display or keyboard in the Controller or pumps.

Solixi is a super system for energy efficiency.